When you want a straightfoward system that's safe and easy to use the IDEC FS1A Safety Controller is the answer.

Unlike a multiple safety relay system, which requires cumbersome wiring and take up too much space, or safety PLCs that can be costly and difficult to program, our safety controllers make it easy to consolidate safety circuits.
At the same time they meet safety requirements, save space with minimal wiring and cost less money.

The IDEC FS1A can replace up to six safety relay modules with no programming. Easily configure by turning on a dip switch to 1 of 8 pre-difined logic circuits and one module can connect with various components such as Emergency Stop switches, Interlock Switches, sensors and light curtains.
With 7 dual channel safety inputs, 4 safety outputs and multiple non safety inputs. FS1A can simplify your complete safety and logic circuit

FS1A is UL listed, TUV rated and CE marked, as well as meets IEC 61508 integrity level 3, ISO 13849-1 performance level e and EN954-1 safety category 4.

• No programming required
• Replaces up to six safety relay modules
• Just select a logic from eight pre-programmed circuits
• One module can connect with various types of safety inputs such as E-stop switches or light curtains
• Easily monitor logic circuit, I/Os and error codes with I/O LEDs and two 7 Segment LED display
• IEC 61508 integrity level 3, ISO 13849-1 performance level e and EN954-1 safety category 4 compliant

The XW Series of E-Stops utilize a revolutionary "SAFE BREAK ACTION" design that forcefully opens the normally closed NC contacts, even if they are welded, and stops the machine.  This unique design reverses the energy direction to ensure that the contacts open if the switch is damage or the contact blocks break off.

IDEC has safety door interlock switches to fill any of your machine safe guarding needs. Our full line of safety door interlocks include a wide range of switch types (solenoid lock, solenoid unlock or non-locking) and sizes to fill any application requirement.

IDEC Enabling Switches

An enabling switch is a 3-position (OFF-ON-OFF) switch to allow a machine operation only when the switch is lightly pressed and held in the middle position (position 2). Because it disables machine operation when released (position 1) or further depressed (position 3) by a panicked operator, the safety of operators is ensured. 

Pepperl+Fuchs Safety Light Curtains

Finger detection 14mm resolution    Protection field height 600mm     Self monitoring type 4

Hand detection 30mm resolution     Proctection field height 1200mm   Self monitoring type 4

Effective detection range 0.4 to 8m    Operating voltage 24 vdc    M12 connectors

Perrerl+Fuchs Safety Sensors